cylinder boundary
英 [ˈsɪlɪndə(r) ˈbaʊndri]
美 [ˈsɪlɪndər ˈbaʊndri]
网络 柱面边界; 柱面界限
双语例句
- This method is proved to be efficient with a horizontal cylinder or an underground vertical boundary of resistivity by the computer imitation of the point source 2D-body.
通过点源二度体的电算模拟实验，证明了该方法在水平柱状体和地下存在电阻率垂直界面的条件下，也是有效的。 - Calculating stresses of the eccentric cylinder in boundary element methode
用边界元法计算受内压小偏心圆筒应力 - The mode of unsteady state thermal stress analysis on cylinder liner and the calculation mode of boundary condition under the transitional working conditions ( including start and stop) are established.
建立过渡工况（起动、停车）气缸套非稳态热应力分析模型以及反映过渡工况特点的边界条件数学模型。 - The models are applied to four hypersonic complex flows with shock wave/ boundary layer interaction. These benchmark flows are: a 2 D supersonic compression corner flow, an ogive cylinder flare flow, and an oblique shock wave/ turbulent boundary layer interaction.
选择四个基准流动&超声速和高超声速二维压缩拐角、锥柱裙组合体绕流和斜激波/平板湍流边界层干扰进行了数值计算。 - Evaluation of cylinder scattering in half-space using the boundary integration method
用边界积分法计算半空间中圆柱体的散射声场 - The hydrodynamic characteristic of a circular cylinder near a plane boundary is closely related with the flow field about.
固壁附近的水平圆柱体在波浪、波流作用下的受力情况与其周围的流场状态密切相关。 - A Numerical Simulation of Unsteady Separated Flow Around a Circular Cylinder at Suction Boundary Conditions
吸气条件对圆柱非定常分离流影响的数值研究 - Analytical solution and numerical simulation of non-Fourier heat conduction models summarizes and comments on predecessors 'results and obtains the analytical solution of hyperbolic heat conduction model for a hollow cylinder with inner and outer boundary surfaces subjected to sudden temperature rise.
本文在总结和评述前人研究成果的基础上对空心圆柱体内、外表面温度突变这类超急速传热问题的双曲线非傅立叶导热模型进行了分析求解和数值模拟。 - Transient simulation of cylinder intake flow under dynamic pressure boundary condition
波动压力下汽油机缸内流场的瞬态数值模拟 - Using the Michell solution and the crack solution, the integral equation of a radial crack in a hollow cylinder reinforced on its outer boundary is derived.
本文结合使用Michell环形域级数解及单裂纹解，导出了外边界被加劲的空心圆柱的径向裂纹积分方程，进而分析了加劲薄膜对裂纹应力强度因子的影响。 - Hydrodynamic forces acting on a circular cylinder near a wavy boundary in steady flow
定常流作用于波浪形边界附近的圆柱上的水动力 - The field coordination equation was numerically solved using Fluent 6.0 for water convection heat transfer in a cylinder with uniform inner heat sources, with boundary conditions similar to those for practical agitator tanks. The regular velocity fields had several vortexes.
该文利用场协同方程，通过Fluent6.0对含有均匀内热源、边界条件与实际搅拌器相近的圆筒内水的对流换热进行数值求解，得到了由多个涡构成的、规则合理的速度场分布。 - The stream function on cylinder is determined by real viscous boundary condition.
在圆柱体表面上用粘性条件确定流函数值。 - Calculation of the Stress Intensity Factors of an Internal and External Surface Crack in a Cylinder with the Boundary Element Method
边界元计算厚壁筒内外表面裂纹应力强度因子 - The flow structure and vortex motion during early and later stages in the near wake of a suddenly started cylinder is studied with a discrete vortex model and the boundary layer theory.
本文用离散涡模型与边界层理论相结合的方法，研究了贺柱突然起动后初期和长期阶段中柱后尾流的流动结构和涡旋运动。 - Numerical Modeling of EM Scattering from Conducting Cylinder Using MEI Absorbing Boundary Condition
基于MEI吸收边界条件的导体柱散射问题模拟 - Spectral methods involving the general cylinder boundary
一般柱形边界区分场的谱方法计算 - In the paper, the method of eigenfunction is applied to obtain the analytical expression of dynamic shear stress of orthotropic thick_walled cylinder under torsion impact to meet the need of mixed boundary conditions.
本文利用特征函数的方法，得到了满足混合边界条件下正交各向异性厚壁圆筒在扭转冲击作用下的动态剪应力的解析表达式。 - Axisymmetric cavitating flows around the cone-capped cylinder are numerically simulated with the boundary element method under potential flow assumption.
基于势流理论和边界元方法，对水下运动的回转体的空泡流进行了数值模拟.将半经验空泡封闭模型由平面流动推广至轴对称流动。 - Solution to the Flow over a Cylinder by the Finite Element and the Boundary Element Methods
二维圆柱绕流有限元与边界元解法 - Flow visualization experiments revealed the wake structure varying with the gap-to-diameter ratio ( G/ D) and mechanism of interaction between the cylinder and the boundary.
流谱显示实验揭示了尾流结构随距离-直径比G/D的变化情况及圆柱与边界相互作用的机制。 - Spline finite strip method for static analysis of cylinder shells has been developed in this paper. In handling the boundary condition, it is more agile than finite strip method.
本文采用样条有限条法计算圆柱壳问题，在边界条件处理上，比半解析有限条法更为灵活，只要对围绕边界点的几个局部样条进行修改，就可以适应任意规定的边界条件。 - The electromagnetic body forces, which is caused by the electromagnetic field and is localized on the circular cylinder surface, have been used to modify the boundary layer of flow and control the flow field of the circular-cylinder flow in electrolyte solution.
利用电介质溶液中圆柱体侧表面附近分布的电磁场产生电磁体积力，作用于流体边界层，从而控制圆柱绕流。 - Propagation characteristics of longitudinal modes in water-filled steel pipe and water cylinder with rigid boundary are studied.
分析了纵向模态在充水钢管和带刚性边界的水圆柱体中传播特性。 - The computation of wave force on a large circular cylinder structure using the direct method of boundary integral equation is presented based on the linear diffraction wave theory.
以线性绕射波理论为基础，采用边界积分方程中直接法计算大尺度圆柱结构上的波浪力。 - Analysis of the Flow and Heat Transfer in Diesel Engine Cylinder with 3 D Boundary Fitted Grids
用三维贴体网格分析柴油机缸内流动和传热 - Sound fields in coaxial cylinder system excited by plane wave and turbulent boundary layer pressure fluctuations
同轴圆管系统由平面声波和湍流边界层压力起伏激发的场 - Givens the algorithm of move nodes around the vibration cylinder boundary, and used the "virtual control unit" to solve the spatial derivative of EFM shape functions so that to deal with the high Reynolds number flow field.
给出了振动圆柱体边界周围节点移动的算法和采用虚拟控制单元的算法，求解EFM形函数的空间导数使其适用于较高雷诺数的流场。 - In this thesis, it takes the cooling system item of a six-cylinder direct injection diesel engine as the research background. The author researched cooling water jacket with CFD method and simulated the temperature field of cylinder head by thermal boundary conditions which obtained from the calculation.
本文以一台六缸直喷式柴油机冷却系统项目为研究背景，应用CFD分析方法研究缸盖冷却水套；并利用仿真计算获得热边界条件，进行缸盖温度场模拟。 - The maximum tangential stress may appear inside the disk or cylinder instead of at the boundary.
最大环向正应力可能出现在圆环/筒的内部，而不是在边界上。